Help & FAQ

Qanto Configurator · Service & Troubleshooting

Start

↳ The Qanto does not move

↳ There are problems during initial start-up

↳ 2. Check all plug connections inside the cabinet (control unit, column, DC bo…

↳ 3. Check the safety cable on the cabinet base.

3. Check the safety cable on the cabinet base.

Solution

The jack plug at the rear right must be reconnected or possibly completely replaced.
Please contact your kitchen studio to order spare parts.
If you require further information, please contact qanto@ninka.com

Instructions, photos & videos

Didn't help? Write to us at Qanto@ninka.com – we are happy to help.

‹ Back Start over

Qanto Configurator · Ninkaplast GmbH · questions: Qanto@ninka.com